Home Sitemap Contact Us


READYFIX-TA A hard wearing, water resistance grout for filling joints of tiles.

Benefits:

  • READYFIX-TG is a hard wearing, water resistance grout for filling joints in exterior and interior walls and floor tiles, mosaics and clinkers up to 5mm width
  • It is easily applied by hand and because of its unique composition does not shrink when dry.

 

Description: READYFIX-TG is a hard wearing, water resistance grout for filling joints in exterior and interior walls and floor tiles, mosaics and clinkers up to 5mm width. It is easily applied by hand and because of its unique composition does not shrink when dry.

Properties: READYFIX-TG is composed of precisely graded, pure crystalline, marble powder, a blend of special cements, water repllent materials, oxide colours and plasticisers. READYFIX-TG does not curl up during application and gives a wear and weather resistant joint eith no shrinkage cracks.

Areas of use: READYFIX-TG can be used on material such as ceramic wall and floor tiles, clinkers and mosaics, where joints do not exceed 5 mm width.

Preparation of surface: ensure all tile joints and edges are clean and free of exceeds tile fixing mortar.

Mixing: Thoroughly mix READYFIX-TG in the ratio of 1 ltr water to 3 kg READYFIX-TG powder. Allows standing for 15 minutes, stirring again before use.

Surfaces: READYFIX-TG can be applied directly on concrete, cement screeds cements lime mortars and existing tiles.

Mixing: READYFIX-TG should be mixed with water in the ratio of 3:1 by volume. Water can be reduced or increased slightly to increase required consistency. A slow speed drill fitted with a suitable mixing paddle is recommended. Hand mixing may be allowed if drill/paddle not available.

Application: wait until READYFIX-TG has set (approx 24 hours) before grouting. Apply READYFIX-TG diagonally in to the joints with a rubbered spatula. Remove excess grout with a moist sponge before drying. Do not apply grout to an area which is large that it cannot be completed with an hour porous tiles should be ministered with water before grouting. After the grout has dried and before it has hardened, polish the tiles with clean dry cloth leaving the joints flush with the tiles, 24 hours after grouting; moisten the joints with a wet sprung.

Consumption: 1 Kg of READYFIX-TG covers approximately 30 running ft with 2 mm width of joint.

Packing and storage: READYFIX-TG is supplied in 25Kg and 5Kg, 5 Kg containers READYFIX-TG should be stored clean, cool, dry area protected from direct light as supplied. Original unopened saks can be stored for 12 months. The information is based only on laboratory work but also on practical experience obtained during field work.

Health & Safety: READYFIX-TG is non-toxic. How ever, splashes on the skin should be washed well with water and if contact with eye occurs wash well with water and seek medical advice.

 

Products
ReadyFix - TA
ReadyFix - TG

Construction Solutions
Home | About Us | Services | Products | Sitemap | Contact Us
   All rights reserved - 2008 © Eurochem Inc. Design & Hosted by: Softwood Hosting